Configure Polling Intervals

About this task

Enable and configure polling intervals to determine how frequently EDM polls for port and LED status changes, or detects the hot swap of installed ports.

Procedure

  1. In the navigation pane, expand Configuration > Device.
  2. Select Preference Setting.
  3. Enable polling or hot swap detection.
  4. Configure the frequency to poll the device.
  5. Select Apply.

Preference Setting Field Descriptions

Use the data in the following table to use the Preference Setting tab.

Name

Description

Enable

Enables polling for port and LED status changes. The default is disabled.

Poll Interval

Specifies the polling interval, if enabled. The default is 60 seconds.

Enable

Detects the hot swap of installed ports. The default is disabled.

Detection per Status Poll Intervals

Specifies the number of poll intervals for detection, if enabled. The default is 2 intervals.