Fabric Engine User Guide Version 9.0.2 > IP Multicast over Fabric Connect > IP SPB Multicast Policy Configuration > IP SPB Multicast Policy Configuration Using CLI

Published March 2024

Search this documentPrint this page

Email this page

View PDF

Previous

Next

About this Document
New in this Document
- Notice about Feature Support
Installation and Commissioning Documentation
Zero Touch Capabilities
Segmented Management
Basic Administration
Command Line Interface
- Command Line Interface Fundamentals
- CLI Procedures
Enterprise Device Manager
Image Management
Address Resolution Protocol
Alternative Routes
Application Telemetry
Bidirectional Forwarding Detection
BGP
Chassis Operations
DHCP and UDP Configuration
Domain Name Service
Distributed Virtual Routing
Extensible Authentication Protocol over LAN
ExtremeCloud IQ Support
Extreme Integrated Application Hosting
Fabric Configuration Work Flow
Fabric Basics and Layer 2 Services
Fabric Layer 3 Services
- IP Shortcuts Configuration
- Layer 3 VSN Configuration
Internet Key Exchange
IP Multicast
IP Multicast over Fabric Connect
IPFIX
IPsec
IPv4 Routing Basics
IPv6 Routing Basics
IPv6 Neighbor Discovery
IPv6-in-IPv4 Tunneling
Key Health Indicators (KHI)
- Key Health Indicators Using the CLI
- Key Health Indicators Using EDM
Layer 2 Security
Licensing
Link Aggregation Control Protocol
Link Layer Discovery Protocol
Link State Change Control
Link-state tracking (LST)
Logs and Traps
MACsec
MultiLink Trunking and Split MultiLink Trunking
Network Operating System Personalities
- Base MAC Address Assignment for Universal Hardware Switches
- Change the Network Operating System Personality
Network Time Protocol
OSPF
Port Performance Management
Power over Ethernet Fundamentals
Power Savings
Quality of Service
RADIUS
RADIUS Attributes
- Vendor Specific Attributes
- IETF Attributes
  - VLAN RADIUS Attributes
    - EGRESS-VLAN-ID
    - EGRESS-VLAN-NAME
  - RADIUS Tunnel Attributes
Representational State Transfer Configuration Protocol (RESTCONF)
RIP
Remote Monitoring
Route Filtering and IP Policies
Routed Split MultiLink Trunking
SD-WAN
Secure Shell
Security
sFlow
Simple Network Management Protocol (SNMP)
Spanning Tree Configuration
SPB-PIM Gateway configuration
System Access
TACACS+
Traffic Filtering
Troubleshooting
Virtual Link Aggregation Control Protocol
VLAN Configuration
VRF Lite
Virtual Router Redundancy Protocol
VXLAN Gateway
Port Numbering and MAC Address Assignment Reference
Supported Standards, RFCs, and MIBs
ICMPv6 Type and Code

IP SPB Multicast Policy Configuration Using CLI

Perform the procedures in this section to configure the IP SPB Multicast Policy using the Command Line Interface (CLI).

9037809-01 Rev AA

Search this documentPrint this page

Email this page

View PDF

Previous

Next

© 2024 Extreme Networks.
Legal
Privacy and Cookies Policy