Configure a Static Foreign Source on a VRF

Configure a static foreign source on a VRF, configuration is done at the Controller.

Procedure

Enter VRF Router Configuration mode for a specific VRF context:

enable

configure terminal

router vrf WORD<1-16>
Configure a static foreign source:

ip spb-pim-gw foreign-source {A.B.C.D} group {A.B.C.D}

In the following example, vrf-10 is configured with vrf id 10.

Switch:1>enable

Switch:1#configure terminal

Switch:1(config)#router vrf vrf-10

Switch:1(router-vrf)#ip spb-pim-gw foreign-source 10.0.0.1 group 240.0.0.1

The following table defines parameters for the ip spb-pim-gw command.


Variable	Value
foreign-source`{A.B.C.D}`	Specifies the multicast foreign source IP address.
group`{A.B.C.D}`	Specifies the group IP address.