Display I-SID Monitoring Diagnostics

Use the following procedure to display the monitor-by-isid entries on the monitoring BEB.

Procedure

  1. Enter Global Configuration mode:

    enable

    configure terminal

  2. Enter the following command:

    show monitor-by-isid WORD<1-1024>

Example

Switch:1>enable
Switch:1#configure terminal
Switch:1(config)# show monitor-by-isid 3
=============================================================================
			Diag Monitor-By-ISID
=============================================================================
ID MONITOR_ISID ISID_OFFSET   EGRESS_PORTS   EGRESS_MLT  MAP_TO_VLAN  ENABLE 
-----------------------------------------------------------------------------
3    16776000       1           1/4, 1/5         1 	     999         true  
-----------------------------------------------------------------------------

Variable Definitions

The following table defines parameters for the show monitor-by-isid command.

Variable

Value

WORD<1-1024>

Specifies the session ID list ranging from 1 to 1000.