Enable RADIUS Accounting

Before you begin

You must configure a RADIUS server before you can enable RADIUS accounting.

About this task

Enable Remote Access Dial-in User Services (RADIUS) accounting to log all of the activity of each remote user in a session on the centralized RADIUS accounting server.

Procedure

Enter Global Configuration mode:

enable

configure terminal
Enable RADIUS accounting globally:

radius accounting enable
Include or exclude CLI commands in RADIUS accounting updates:

radius accounting include-cli-commands
Specify the integer value of the CLI commands attribute:

radius accounting attribute-value <192–240>

Example

 Switch:1> enable 
 Switch:1# configure terminal 
 Switch:1(config)# radius accounting enable 
 Switch:1(config)# radius accounting include-cli-commands

Variable Definitions

The following table defines parameters for the radius accounting command.


Variable	Value
enable	Enable RADIUS globally.
include-cli-commands	Include CLI commands in RADIUS accounting updates.
attribute-value `<192–240>`	Specify the integer value of the CLI commands attribute.