VRRP Transitions

When a VRRP transition takes place with the backup taking over as the master, look for the following message in the syslog on the new master, as well as the old master. This message provides information to allow you to determine the cause of the transition.

IPv6 Vrrp State Transition Trap(Port/Vlan=200, Type=masterToInitialize, Cause=shutdownReceived, VrId=20,VrIpAddr=fe80:0:0:0:0:0:0:200, Addr=fe80:0:0:0:224:7fff:fe9d:1a03)

In this message, see the Type and Cause fields.

Note

Note

Although the possible causes and types are listed in the following table, the system does not display all of the listed causes and types in the trap/log message.

The following table describes the VRRP transition types.

Table 1. Transition type

Type value

Type definition

1

None

2

Master to backup

3

Backup to master

4

Initialize to master

5

Master to initialize

6

Initialize to backup

7

Backup to initialize

8

Backup to backup master

9

Backup master to backup

The following table describes the VRRP transition causes.

Table 2. Transition cause

Cause value

Cause definition

1

None

2

Higher priority advertisement received

3

Shutdown received

4

VRRP address and physical address match

5

Master down interval

6

Preemption

7

Critical IP goes down

8

User disabling VRRP

9

VRRP status synced from primary

10

IPv6 interface on which VRRP is configured goes down

11

Lower priority advertisement received

12

Advertisement received from higher interface IP address with equal priority

13

Advertisement received from lower interface IP address with equal priority

14

User enabled VRRP

15

Transition because of any other cause