Enable a Switch as a DvR Leaf Node

Enables an SPB node to be configured as a DvR Leaf.

About this task

A node that has this flag configured cannot be configured as a DvR Controller.

The boot flag is disabled by default.

Note

Note

The switch does not require a restart when you enable the dvr-leaf-mode flag, as long as there is no unsupported configuration on the switch.

Procedure

  1. Enter Global Configuration mode:

    enable

    configure terminal

  2. Enable the node as a DvR Leaf:

    boot config flags dvr-leaf-mode

  3. Save the changed configuration.
9037809-01 Rev AA