Display BFD Configuration for an IPv4 Interface
About this task
Use the following procedure to display BFD configuration on an interface.
Procedure
Examples
The following example displays VLAN interface configuration information for BFD.
Switch:1>show ip bfd interfaces vlan 11 ========================================================================================== Vlan Bfd ========================================================================================== VLAN STATUS MIN_RX INTERVAL MULTIPLIER VRF-ID ------------------------------------------------------------------------------------------ 11 enable 200 200 3 0
Switch:1>enable Switch:1#show ip bfd interfaces loopback ================================================================================ Circuitless IP Interface Bfd ================================================================================ INTF ID STATUS MIN_RX INTERVAL MULTIPLIER VRF-ID -------------------------------------------------------------------------------- 1 enable 200 200 3 0 2 enable 200 200 3 2
Variable Definitions
The following table defines parameters for the show ip bfd interfaces command.
Variable |
Value |
---|---|
{slot/port[/sub-port][-slot/port[/sub-port]][,...]} |
Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port. |
<1-4059> |
Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1. |
vrf WORD<1-16> |
Specifies a VRF instance by VRF name. |
vrfids WORD<0-512> |
Specifies a VRF or range of VRFs by ID. |