Configure LLDP-MED Emergency Call Service Location

1. Enter GigabitEthernet Interface Configuration mode:

   enable

   configure terminal

   interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}

   

   Note

   If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

2. Configure emergency call service location:

   lldp location-identification ecs-elin WORD<10-25>

Example

Configuring emergency call service location on port 2/1–2/3:

Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#interface gigabitEthernet 2/1–2/3
Switch:1(config-if)#lldp location-identification ecs-elin 123456789