Migrate an IP Address to a Segmented Management Instance

Perform this procedure to migrate a new routing VLAN with a new IP address or a new loopback IP address under a different VRF to the Segmented Management Instance. Alternatively, you can also use the convert command.

Important

Important

Choose a VLAN that does not have an IP interface on it. The upgrade process removes the IP configuration and network connectivity will be impacted.

About this task

You cannot migrate interfaces used for routing purposes, for example, where you configure Layer 3 routing protocols.

This command does not apply to the OOB or mgmtEthernet interface. Releases that support this migration procedure automatically move the IP address on the mgmtEthernet interface from the routing stack to the Segmented Management Instance.

Procedure

  1. In the navigation pane, expand Configuration > Edit.
  2. Select Mgmt Instance.
  3. Select Mgmt.
  4. Select the Migrate tab.
  5. Select Insert.
  6. Select the instance type, either clip or vlan.
  7. Specify the existing VLAN or loopback ID.
  8. Select Insert.

Migrate Field Descriptions

Use the data in the following table to use the Migrate tab.

Name

Description

InstanceId

Specifies the interface instance to migrate.

InterfaceIndex

Shows the interface index of the identified interface.

InterfaceType

Shows the interface type.

Description

Shows the interface description.

VlanId

Specifies the VLAN ID for a port-based VLAN.

LoopbackId

Specifies the loopback ID.

VrfName

Shows the VRF associated with the loopback interface.

IpAddress

Shows the IPv4 address to migrate.

IpMask

Shows the subnet mask for the IPv4 address.

Ipv6Address

Shows the IPv6 address to migrate.

Ipv6PrefixLength

Shows the prefix length for the IPv6 address.