Configure Disks to be used by the Virtual Service

About this task

Perform the following procedure to configure the number of disks to be used by the virtual service configured on the switch.

Procedure

  1. In the navigation pane, expand Configuration > Serviceability.
  2. Select Virtual Service.
  3. Select the Disks tab.
  4. Select Insert.
  5. In the ServName field, enter the virtual service name.
  6. In the Name field, enter the disk name.
  7. Optional: In the Size field, enter a value.
  8. Select Insert.

Disks Field Descriptions

Use data in the following table to use the Disks tab.

Name

Description

ServName

Specifies the virtual service name.

Note:

The specified name must match the virtual service name configured on the switch.

Name

Specifies the name of the disk used by the virtual service.

Size

Specifies the disk size (in Gigabytes). The default is 10 Gigabytes.

SizeAllot

Shows the disk size (in Megabytes) allocated to the virtual service.

SizeAvailable

Shows the available disk storage space (in Megabytes).

SizeUsed

Shows the amount of disk storage space (in Megabytes) used by the virtual service.