Configure Route Redistribution to RIP

Configure a redistribute entry to announce routes of a certain source protocol type into the RIP domain, for example, static, RIP, or direct. Use a route policy to control the redistribution of routes.

Before you begin

  • Enable RIP globally.

  • Configure a route policy.

  • Change the VRF instance as required to configure RIP on a specific VRF instance. The VRF must have an RP trigger of RIP. Not all parameters are configurable on non-default VRFs.

About this task

Important

Important

Changing the RIP redistribute context is a process-oriented operation that can affect system performance and network reachability while you perform the procedures. As a best practic, change default preferences for a RIP redistribute context, you must do so before you enable the protocols.

Procedure

  1. In the navigation pane, expand Configuration > IP.
  2. Select RIP.
  3. Select the Redistribute tab.
  4. Select Insert.
  5. Configure the source of the routes to redistribute.
  6. Select enable.
  7. Select the route policy to apply to redistributed routes.
  8. Configure a metric value.
  9. Select Insert.

Redistribute Field Descriptions

Use the data in the following table to use the Redistribute tab.

Name

Description

DstVrfId

Specifies the destination VRF instance. You cannot configure this variable.

Protocol

Specifies the dynamic routing protocol that receives the external routing information.

SrcVrfId

Specifies the source VRF instance. You cannot configure this variable.

RouteSource

Specifies the route source protocol for the redistribution entry.

Enable

Enables (or disables) a RIP redistribute entry for a specified source type.

RoutePolicy

Configures the route policy (by name) that redistributes external routes from a specified source into an RIP domain.

Select the ellipsis (...) and choose from the list in the Route Policy dialog box.

Metric

Configures the RIP route redistribution metric for basic redistribution. The value can be in the range 0–65535. A value of 0 indicates to use the original cost of the route.