Enable PIM on a CLIP Interface

Enable Protocol Independent Multicasting (PIM) on a CLIP interface so that it can participate in PIM routing.

Before you begin

  • You must globally enable PIM.

Procedure

  1. In the navigation pane, expand Configuration > IP.
  2. Select IP.
  3. Select the Circuitless IP tab.
  4. Select the required CLIP interface.
  5. Select PIM.
  6. Select Enable.

    You must enable PIM on the CLIP interface for PIM to function. The mode is indicated on this tab.

  7. Select Apply.

Circuitless PIM Field Descriptions

Use the data in the following table to use the Circuitless PIM tab.

Name

Description

Enable

Enables PIM on the CLIP interface.

Mode

Specifies the PIM mode.

9037809-01 Rev AA