Configure SPBM IPv6 Layer 3 VSN

Before you begin

You must enable IPv6 Shortcuts.
You must configure the required SPBM IS-IS infrastructure.
You must configure a VRF and IPv6 VPN instance on the switch. For more information, see VRF Lite configuration using Enterprise Device Manager.

About this task

After you have configured the SPBM infrastructure, you can enable SPBM Layer 3 Virtual Services Network (VSN) to advertise IPv6 routes across the SPBM network from one VRF to another using the following procedure.

SPBM Layer 3 VSN uses IS-IS to exchange the routing information for each VRF.

Procedure

In the navigation pane, expand Configuration > IPv6.
Select IPv6-VPN.
Select the VPN tab.
Select Insert.
Select the ellipsis [...], and select a VRF.
Select Ok.
Select Insert.
In IsidNumber, double-click the 0 value, and then enter the service instance identifier (I-SID) to assign to the IPv6-VPN.
Select Apply.
In Enable, select true or false.
Select Apply.
In the navigation pane, expand Configuration > VRF Context View.
Select Set VRF Context View.
Select the VRF tab.
Select a context to view.
Select Launch VRF Context view.
In the navigation pane, expand Configuration > IPv6.
Select IS-IS.
Select the Redistribute tab.
Select Insert.
Configure the parameters as required.
Select Insert.
Select Apply.