Configure RIPng Globally

Configure RIPng global parameters on the switch so you can control RIPng behavior on the system.

About this task

All router interfaces that use RIPng use the RIPng global parameters. Both brouter ports and VLAN virtual routing interfaces use the same RIPng global parameters.

You can configure RIPng on interfaces while RIPng is globally disabled. This way, you can configure all interfaces before you enable RIPng for the switch

Procedure

  1. In the navigation pane, expand Configuration > IPv6.
  2. Select IPv6 RIPng.
  3. Select the Globals tab.
  4. Select enable.
  5. Configure other global RIPng parameters as required.
  6. Select Apply.

Globals Field Descriptions

Use the data in the following table to use the Globals tab.

Name

Description

AdminState

Enables or disables RIPng globally. The default is disabled.

UpdateTime

Specifies the time interval between RIPng updates for all interfaces. The default is 30 seconds, and the range is 1–360.

GlobalHoldDownTime

Configures the length of time that RIPng continues to advertise a network after the network is unreachable. The range is 0–360 seconds. The default is 120 seconds.

GlobalTimeOutInterval

Configures the RIPng timeout interval. The range is 15–259200 seconds. The default is 180 seconds.

DefaultInfoMetric

RIPng default-information metric.

DefaultInfoState

Default-information enable or disable at the global level

DefaultImportMetric

Specifies the RIPng default import metric.