Configure Remote IS-IS Layer 1 Designated Router Priority on a Port

About this task

Perform this procedure to configure the Level 1 remote Intermediate-System-to-Intermediate-System (IS-IS) designated router priority to the specified value.

Procedure

Enter GigabitEthernet Interface Configuration mode:

enable

configure terminal

interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}

Note

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
Configure the Level 1 remote IS-IS designated router priority:

isis remote l1-dr-priority <0-127>

Example

Configuring the remote IS-IS designated router priority for port 1/4:

Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#interface gigabitEthernet 1/2
Switch:1(config-if)#isis remote l1-dr-priority 1

Variable Definitions

The following table defines parameters for the isis remote l1-dr-priority command.


Variable	Value
`<0-127>`	Specifies the level 1 remote Intermediate-System-to-Intermediate-System (IS-IS) designated router priority value. The default value is 64.