Use this procedure to provide a descriptive name for the Service Identifier (I-SID).

Configure a Global I-SID Name

Use this procedure to provide a descriptive name for the Service Identifier (I-SID).

You can configure a service name for I-SIDs, loopback interfaces, and static routes. You can configure the service name can before or after you create the I-SID for the following services:

  • Layer 2 VSN
  • Layer 3 VSN
  • ELAN I-SID or Switched UNI I-SID
  • ELAN transparent I-SID or Transparent UNI I-SID
  • IPv4 and IPv6 static routes
  • IPv4 and IPv6 loopback CLIP interface
Note

Note

The service name for I-SIDs does not support the following special characters: “ ” # $ % ‘ / [ \ ] ^ { | } ~ @.

By default, the service name is ISID-x, where x correlates to the I-SID number of the service.

Procedure

  1. Enter Global Configuration mode:

    enable

    configure terminal

  2. Enter a name for the global I-SID.
    i-sid name <1-6777215> WORD<1-64>
  3. Display I-SID names for all configured I-SIDs.
    show i-sid name
  4. Display I-SID name by I-SID.
    show i-sid name <1-6777215>

Example

Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#i-sid name 1 ExtremeServer1
Switch:1(config)#i-sid name 20 ExtremeServer7

View the configured I-SID names:

Switch:1(config)#show i-sid name
=========================================================================
                          I-SID Name
=========================================================================
I-SID           I-SID NAME                      TYPE
-------------------------------------------------------------------------
1               ExtremeServer1                  adminName
2               ExtremeServer2                  adminName
3               ExtremeServer3                  config adminName
4               ISID-4                          config
23              ISID-23                         config
25              ExtremeServer4                  config adminName

Total number of I-SID Name entries: 6.

View the configured I-SID by number:

Switch:1#show i-sid name 1
=======================================================================
                           I-SID Name
=======================================================================
I-SID           I-SID NAME                TYPE 
-----------------------------------------------------------------------
1               ExtremeServer1            adminName
Switch:1#show i-sid name 20
=======================================================================
                           I-SID Name
=======================================================================
I-SID           I-SID NAME                TYPE 
-----------------------------------------------------------------------
20              ExtremeServer7            adminName

Variable Definitions

Use the data in the following table to use the i-sid name command.

Variable

Value

<1-6777215>

Specifies the I-SID number.

WORD<1-64>

Specifies the name of the I-SID. The I-SID can be named before or after the I-SID is created.

By default, for an I-SID in use, the service is named ISID-x, where x correlates to the I-SID number of the service.