Rename an ACL

Perform this procedure to change the name of an existing ACL.

Procedure

  1. Enter Global Configuration mode:

    enable

    configure terminal

  2. Rename an ACL:

    filter acl <1-2048> name WORD<0–32>

  3. Reset the ACL name to the default name:

    default filter acl <1-2048> name

Variable definitions

Use the data in the following table to use filter acl command.

Variable

Value

<1-2048>

Specifies the ACL ID.

enable

Enables the ACL state, and all associated ACEs. Enabled is the default state.

matchType <both|terminatingNNIOnly|uniOnly>

For inVsn ACL types, specifies the match type to associate with the ACL. Valid options are:
  • both for traffic ingressing on both UNI ports and network-to-network interface (NNI) ports terminating on this node

  • terminatingNNIOnly for traffic ingressing on NNI ports only and terminating on this node

  • uniOnly for traffic ingressing on UNI ports only

The default value is both.

name WORD<0-32>

Specifies an optional descriptive name for the ACL.

type <inVlan|inPort|outPort|inVsn>

Specifies the ACL type. The values inVlan, inPort, and inVsn are ingress ACLs, and outPort is an egress ACL.

A port-based ACL has precedence over a VLAN-based ACL.