Configure Remote IS-IS SPBM Parameters on a Port

About this task

Perform this procedure to configure the remote Intermediate-System-to-Intermediate-System (IS-IS) Shortest Path Bridging MAC (SPBM) parameters on a specific port.

Procedure

Enter Interface Configuration mode:

enable

configure terminal

interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]} or interface mlt <1-512>

Note

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
Configure the remote IS-IS SPBM interface type:

isis remote spbm <1-100> interface-type {broadcast | pt-pt}
Configure the cost of the remote SPBM instance:

isis remote spbm <1-100> l1-metric {<1-16777215> | auto}

Example

Configuring the remote IS-IS SPBM interface type and layer 1 metric on port 1/2:

Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#interface gigabitEthernet 1/2
Switch:1(config-if)#isis remote spbm 2 interface-type broadcast
Switch:1(config-if)#isis remote spbm 2 l1-metric 2

Variable Definitions

The following table defines parameters for the isis remote spbm command.


Variable	Value
`<1-100>`	Specifies the SPBM instance.
interface-type `{broadcast \| pt-pt}`	Specifies the IS-IS SPBM interface type as broadcast or point-to-point (pt-pt).
l1-metric `{<1–16777215> \| auto}`	Specifies the SPBM instance Level 1 metric on the IS-IS interface located on a specific port. You can configure a static value, or use auto. When you use the auto setting, the network route is determined by summing the lowest value metrics, which are inversely proportional to port speed.