Configure Multi-area SPB Layer 3 Redistribution in Home Area

About this task

Perform this procedure to configure Multi-area SPB Layer 3 redistribution in the home area.

Procedure

  1. In the navigation pane, expand Configuration > Fabric.
  2. Select MultiArea.
  3. Select the L3 Redist Home tab.
  4. Select Insert.
  5. In the VrfId field, type the Virtual Router Forwarding ID.
  6. In the Type field, select the Layer 3 redistribution type.
  7. Optional: In the RoutePolicy field, type the name of the redistribution policy.
  8. Select Enable.
  9. In the Apply field, select apply.
  10. Select Insert.

L3 Redist Home Field Descriptions

Use the data in the following table to use the L3 Redist Home tab.

Name Description

VrfId

Specifies the Virtual Router Forwarding ID.

Type

Specifies the layer 3 redistribution type. The options are:

  • ip-ucast - IPv4 unicast
  • ip-mcast - IPv4 multicast
  • ipv6-ucast - IPv6 unicast

RoutePolicy

Associates a route policy to a specific layer 3 redistribution entry in the home area.

Enable

Enables layer 3 redistribution in the home area. The default value is disabled.

Apply

Applies the Multi-area SPB layer 3 redistribution filters in the home area. The default value is noAction.
9037809-01 Rev AA