configure ip nat aging-time

configure ip nat aging-time [minutes | none]

Description

Configures the time after which dynamic IP Network Address Translation (NAT) entries that are not active are removed.

Syntax Description

ip Specifies Internet Protocol (IP).
nat Specifies NAT.
aging-time Configures the time after which dynamic IP Network Address Translation (NAT) entries that are not active are removed.
minutes Specifies the aging time in minutes. The default is 20 minutes. The range is 10 to 3,000 minutes.
none Specifies not perform aging of NAT entries.

Default

By default, the aging time is 20 minutes.

Usage Guidelines

Example

The following example configures the NAT aging time to 45 minutes.

# configure ip nat aging-time 45

History

This command was first available in ExtremeXOS 31.2.

Platform Availability

This command is available on the switches that support the IP NAT feature. For information about which switches support this and other features, see the ExtremeXOS and Switch Engine 31.7 Feature License Requirements document.