Configures gPTP synchronization parameters on the specified ports.
| port_list | Specifies one or more of the switch's physical ports. |
| only | Apply change only to specified port, even if port is master of a load sharing group. |
| all | Specifies all of the switch's physical ports. |
| log_2_interval | The interval between Sync messages used by the switch for the port when the port is initialized or when the switch receives a message interval request TLV with timeSyncInterval value of 126. This value is in log2 seconds. The valid range of values is -3 (2-3 = 0.125 seconds) to 17 (217 = 131072 seconds). |
| timeout_count | On a gPTP slave port, the number of sync intervals to wait without receiving a Sync message before assuming the adjacent master port is no longer sending Sync messages. |
initial-interval corresponds to 802.1AS parameter initialLogSyncInterval.
receipt-timeout corresponds to 802.1AS parameter syncReceiptTimeout.
configure network-clock gptp ports 1-2 sync initial-interval -1 configure network-clock gptp ports all sync receipt-timeout 5
This command was first available in ExtremeXOS 15.3.
This command is available on platforms that support the AVB feature pack license and have it installed. For complete information about software licensing, including how to obtain and upgrade your license, and which platforms support the AVB feature, see the ExtremeXOS and Switch Engine 31.7 Feature License Requirements document.