Use this command to show the remote-endpoints that have been created.
| vn_name | Display remote endpoints only for the specified Virtual Network string. |
| vni | A unique 24-bit Virtual Network Identifier that is used in the VXLAN header to encapsulate tenant frames. |
| vni | Virtual Network Identifier value between 1 and 16777215. |
| ipaddress | IP address of the remote endpoint. |
| ipaddress | A remote endpoint IP address |
N/A.
When no VXLAN name or VNI is specified a summary output of all remote endpoints appears. You need to supply the virtual network name or VXLAN VNI to query the remote endpoints associated to a specific virtual network. To display detailed information about a specific remote-endpoint, use the ipaddress option.
# show virtual-network remote-endpoint vxlan
IP Address Virtual Router Next Hops Virtual Active/Total Networks
===================================================================
200.1.1.1 VR-Default 2/2 2
200.1.1.2 VR-Default 2/2 1
200.1.1.3 VR-Default 2/2 1
200.1.1.4 VR-Default 2/2 1
200.200.200.200 VR-Default 0/0 0
===================================================================
Total number of Remote Endpoints : 5
# show virtual-network vxlan
remote-endpoint ipaddress 3.3.3.3
IP Address : 3.3.3.3 VRF : VR-Default
Learning : Enabled Stats Monitor : On
Health Check : None
== Next Hop Information ==
Gateway : 22.0.0.1 MAC : 00:04:96:97:f8:a6
Interface : trunk2 Port : 1:41
== End Next Hop Information ==
== Virtual Network Associations ==
Virtual Network : vni1 VNI : 1
Origin : OSPF Learned,
Virtual Network : vni2 VNI : 2
Origin : OSPF Learned,
== End Virtual Network Associations ==
# show virtual-network remote-endpoint vxlan ipaddress 100.1.1.1
IP Address : 100.1.1.1 VRF : VR-Default
Admin State : Enabled
Learning : Enabled Stats Monitor : Off
== Next Hop Information ==
Gateway : 50.50.50.1 MAC : 00:04:96:9a:92:b7
Interface : s1 Port : 1:45
== End Next Hop Information ==
== Virtual Network Associations ==
Virtual Network : vn1 VNI : 1
Origin : OSPF Learned,
== End Virtual Network Associations ==
This command was first available in ExtremeXOS 21.1.
Information about the remote endpoint's administrative state was added in ExtremeXOS 22.4.
This command is supported on the ExtremeSwitching X670-G2, X465, X590, X690, X695, X870, 5320, 5420 , 5520 series switches, and stacks with X465, X590, X670-G2, X690, X695, X870, 5320, 5420, 5520 slots only.