configure ospfv3 interface timer

configure ospfv3 [vlan vlan_name | tunnel tunnel_name | [vlan | tunnel] all] timer {retransmit-interval} retransmit_interval {transit-delay} transit_delay {hello-interval} hello_interval {dead-interval} dead_interval

Description

Configures the timers for all interfaces in the same OSPFv3 area.

Syntax Description


`vlan_name`	Specifies an IPv6 configured This command is available on the ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X590, X620, X670-G2, X690, X695, X870, 5320, 5420, 5520 series switches..
`tunnel_name`	Specifies an IPv6 tunnel.
all	Specifies all IPv6 configured VLANs or all IPv6 tunnels.
`retransmit_interval`	Specifies the length of time that the router waits before retransmitting an LSA that is not acknowledged. The range is 1 to 3600 seconds.
`transit_delay`	Specifies the length of time it takes to transmit an LSA packet over the interface. The range is 1 to 3600 seconds.
`hello_interval`	Specifies the interval at which routers send hello packets. The range is 1 to 65535 seconds.
`dead_interval`	Specifies the interval after which a neighboring router is declared down due to the fact that hello packets are no longer received from the neighbor. The range is 1 to 65535 seconds.

Default

Retransmit interval—Default: 5 seconds.
Transit delay—Default: 1 second.
Hello interval—Default: 10 seconds.
Dead interval—Default: 40 seconds.

Usage Guidelines

Use this command to configure the OSPFv3 timers on a per-interface basis.

Specify the following:

retransmit interval—If you set an interval that is too short, unnecessary retransmissions will result.
transit delay—The transit delay must be greater than 0.
hello interval—Smaller times allow routers to discover each other more quickly, but also increase network traffic.
dead interval—This interval should be a multiple of the hello interval.

The value of the dead interval and the hello interval must be same for all OSPFv3 routers connected to a common link. The value of the dead interval and the hello interval are advertised by OSPFv3 in Hello packets. The shorter the hello interval, the earlier topological changes will be detected, but more routing traffic will ensue.

The retransmit interval must be greater than the expected round trip delay between any two routers on the attached network. The setting of this parameter must be conservative, or needless retransmission will result.

Note

The wait interval for the interface is not separately configurable. It is always equal to the dead interval.

Example

The following command sets the timers for the VLAN corporate:

configure ospfv3 vlan corporate timer retransmit-interval 10 transit-delay 2 hello-interval 20 dead-interval 80

History

This command was first available in ExtremeXOS 11.2.

Platform Availability

This command is available on platforms with an Advanced Edge or Base license, or higher, as described in the ExtremeXOS and Switch Engine 31.7 Feature License Requirements document.