unconfigure sflow collector

unconfigure sflow collector {ipaddress} ipaddress {port udp-port-number} {vr vr_name}


Unconfigures the sFlow collector.

Syntax Description

ipaddress Specifies the IP address of the collector to reset.
udp-port-number Specifies the UDP port.
Specifies which virtual router.
Note: User-created VRs are supported only on the platforms listed for this feature in the ExtremeXOS and Switch Engine 31.7 Feature License Requirements document.


The following values are the defaults for this command:
  • UDP port number—6343
  • Virtual router—VR-Mgmt (previously called VR-0)

Usage Guidelines

This command allows you to reset the specified sFlow collector parameters to the default values.

Both the commands unconfigure ports monitor vlan and unconfigure sflow collector will reset the collector parameters to the default.


The following command removes the collector at IP address

unconfigure sflow collector ipaddress 192.168.57.


This command was first available in ExtremeXOS 11.0.

Platform Availability

This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, X670-G2, X690, X695, X870, 5320, 5420, and 5520 series switches.