Configure the value of the PTP announce interval time on the port(s) for sending announce messages. This command is available only for boundary and ordinary clocks. The interval time is the time between successive announce messages.
| boundary | Boundary clock instance. |
| ordinary | Ordinary clock instance. |
| seconds_log_base_2 | The log base 2 value of the seconds between successive announce messages. For example, to specify 8 seconds, use 3. The default value is 1, and the range is -2 to 4. |
| vlan_name |
Name of the This command is available on the ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X590, X620, X670-G2, X690, X695, X870, 5320, 5420, 5520 series switches. to apply the command to. |
The default value of the announce interval is log base 2 (1), or 2 seconds.
Use this command to configure the value of PTP announce interval time on the port(s) for sending announce messages. The announce interval is set using log base 2 values. The range is -2 to 4. This command is available only for boundary and ordinary clocks.
The following example configures announce interval to be 1/second on the clock port lpbk-gm of the ordinary clock:
# configure network-clock ptp ordinary announce interval 0 vlan lpbk-gm
The following example configures announce interval to be 2/second on the clock-port lpbk-gm of the boundary clock:
# configure network-clock ptp boundary announce interval -1 vlan lpbk-gm
This command was first available in ExtremeXOS 15.1.
This command is available on ExtremeSwitching X670-G2, and X460-G2 series switches.
Note
PTP commands can be used only with the Network Timing feature pack.