Displays the configuration for the specified profile.
| profile_name | Displays configuration and usage information for the specified profile, which can be either a standard or a fast-reroute profile. |
| detail | Displays the profile information in verbose format, and displays all LSPs that are configured to use the specified profile. |
N/A.
If the profile_name argument is omitted, the profile parameter values for all profiles are displayed.
The following command displays configuration information for all defined profiles:
# show mpls rsvp-te profile Profile Name Peak Committed Max Burst SPri HPri RRO MTU #LSP ----------------- ---------- ---------- --------- ---- ---- --- ---- ---- default 0 0 0 7 0 Off i/f 0 prof598 0 0 0 7 0 On 1500 1 FRR Profile Name Mode Bandwidth SPri HPri HopLmt P-BW P-Node #LSP ---------------- ------ --------- ---- ---- ------ ---- ------ ---- Prf1_frr Detour 0 7 0 3 Ena Ena 2
The following command displays configuration information for a specific fast-reroute profile:
# show mpls rsvp-te profile prf1_frr detail Profile Name : prf1_frr Profile type : Fast Reroute / Standard Peak Rate : 0 Kbps Committed Rate : 0 Kbps Max Burst Size : 0 Kb Setup Priority : 7 Hold Priority : 4 Hop Limit : 1 Protected BW : Disabled Protect Node : Enabled #LSP References : 2 LSP / Path : pc10_lsp / p1
This command was first available in ExtremeXOS 11.6.
The fast-reroute feature was first available in ExtremeXOS 12.1.
This command is available only on the platforms that support MPLS as described in the ExtremeXOS and Switch Engine 31.7 Feature License Requirements document.