Enables the bundling of RSVP-TE messages for the specified This command is available on the ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X590, X620, X670-G2, X690, X695, X870, 5320, 5420, 5520 series switches. interface.
| vlan | Specifies that message-bundling is to be enabled on one or more VLAN interfaces. |
| vlan_name | Identifies a VLAN interface for which message bundling is to be enabled. |
| vlan all | Specifies that message bundling is to be enabled on all VLANs that have been added to MPLS. |
Disabled.
Enabling message bundling can improve control plane scalability by allowing the switch to bundle multiple RSVP-TE messages into a single PDU. Not all devices support bundled messages. If the switch determines that a peer LSR, connected to a specific interface, does not support message bundling, the switch reverts to sending separate PDUs for each message on that interface. By default, message bundling is disabled. Specifying the all keyword enables message bundling on all MPLS-configured VLANs.
The following command enables message bundling on the specified VLAN:
enable mpls rsvp-te bundle-message vlan vlan_1
This command was first available in ExtremeXOS 11.6.
This command is available only on the platforms that support MPLS as described in the ExtremeXOS and Switch Engine 31.7 Feature License Requirements document.