Adds an MLD SSM Mapping entry on a VR.
| v6groupnetmask | You must provide group address with the mask length. Instead of configuring separate entries for a continuous range of IP addresses, this optimizes a range of group IP addresses to be configured as a single entry. |
| v6sourceip | Specifies the source IP address for which the SSM should apply. |
| src_domain_name | Provides the option to use DNS to obtain IP addresses dynamically by specifying the domain name. |
| VR vr_name | Specifies the virtual router name. |
N/A.
When an MLDv1 report is received for this group or group range, the list of sources configured using this command is used as part of source-specific information to PIM.
The following error message displays when more than 50 source addresses are configured for a specific group:
ERROR: Cannot configure more than 50 sources for group ff30::1/128 on VR-Default
The following error message displays when a source address is already configured:
ERROR: Source 2001:0DB8:1::1 already present for group ff30::1/128 on VR-Default
The following error message displays when a DNS name is already configured:
ERROR: Only one source domain name allowed for group ff30::1/128 on VR-Default
The following example configures a MLD-SSM mapping entry:
configure mld ssm-map add ff06::/64 2001::1
This command was first available in ExtremeXOS 15.5.
This command is available on the platforms listed for the IPv6 multicast routing feature in the ExtremeXOS and Switch Engine 31.7 Feature License Requirements document.