Unconfigures the This command is available on the ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X620, 5320, 5420, 5520 series switches. priority on the specified ports, and returns the ports to the default PoE port priority value of low.
| all | Specifies all ports. |
| port_list | Specifies one or more ports or slots and ports. |
Low.
Use this to reset the PoE port priority on specified ports on switches to the default value of low.
If there are multiple ports on the switch at the same priority level (either configured, or by default) and one of the ports must have power withdrawn because of excessive power demands, those ports with the lower port number are powered first. The higher port numbers have power withdrawn first in the case of equal PoE port priorities.
The following command resets the PoE priority on ports 4 – 6 to low:
unconfigure inline-power priority ports 4-6
This command was first available in ExtremeXOS 11.1.
This command is available on the PoE devices listed in Extreme Networks PoE Devices.