enable ripng splithorizon

enable ripng splithorizon {vlan vlan-name | tunnel tunnel_name | [vlan | tunnel] all}

Description

Enables the split horizon algorithm for RIPng.

Syntax Description

vlan-name Specifies an IPv6 configured This command is available on the ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X590, X620, X670-G2, X690, X695, X870, 5320, 5420, 5520 series switches..
tunnel_name Specifies an IPv6 tunnel.
all Specifies all interfaces.

Default

Enabled.

Usage Guidelines

Split horizon is a scheme for avoiding problems caused by including routes in updates sent to the router from which the route was learned. Split horizon omits routes learned from a neighbor in updates sent to that neighbor.

Example

The following command enables the split horizon algorithm for RIPng on all IPv6 configured interfaces:

enable ripng splithorizon

History

This command was first available in ExtremeXOS 11.2.

Platform Availability

This command is available on platforms with an Edge, Advanced Edge, or Core license. For licensing information, see the ExtremeXOS and Switch Engine 31.7 Feature License Requirements document.