Configures the server information for a TACACS+ authentication server.
| primary | Configures the primary TACACS+ server. |
| secondary | Configures the secondary TACACS+ server. |
| ipaddress | The IP address of the TACACS+ server being configured. |
| hostname | The host name of the TACACS+ server being configured. |
| tcp_port | The TCP port to use to contact the TACACS+ server. |
| ipaddress | The IP address used by the switch to identify itself when communicating with the TACACS+ server. |
| vr_name | Specifies the virtual router
on which the client IP is located. Note: User-created VRs are
supported only on the platforms listed for this feature in the
ExtremeXOS and Switch Engine 31.7 Feature License Requirements
document.
|
TACACS+ uses TCP port 49. The default virtual router is VR-Mgmt, the management virtual router.
Use this command to configure the server information for a TACACS+ server.
To remove a server, use the following command:
unconfigure tacacs server [primary | secondary]Use of the hostname parameter requires that DNS be enabled.
The following command configures server tacacs1 as the primary TACACS+ server for client switch 10.10.20.35 using a virtual router interface of VR-Default:
configure tacacs primary server tacacs1 client-ip 10.10.20.35 vr vr-Default
This command was first available in ExtremeXOS 10.1.
This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, X670-G2, X690, X695, X870, 5320, 5420, and 5520 series switches.