Configures Authentication Trailer with a manual key to provide authentication on OSPFv3 interfaces.
| ospfv3 | Specifies OSPFv3 interface. |
| vlan | Specifies OSPFv3 VLAN. |
| vlan-name | Specifies an IPv6 configured This command is available on the ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X590, X620, X670-G2, X690, X695, X870, 5320, 5420, 5520 series switches.. |
| tunnel | Specifies Layer 3 tunnel. |
| tunnel-name | Specifies Layer 3 tunnel name. |
| authentication | Specifies interface authentication. |
| keychain | Specifies the set of authentication keys. |
| keychain-name | Specifies the keychain name. |
| none | Specifies no authentication (default). |
If not specified, no authentication is applied.
Users can only add keychains that are already present in the system. To add a keychain, run the command create keychain keychain_name .
The following example for VLAN "vlan1" applies authentication type Authentication Trailer:
# configure ospfv3 vlan1 authentication keychain ospfv3-keys1
This command was first available in ExtremeXOS 31.3.
This command is available on platforms with an Advanced Edge or Base license, or higher, as described in the ExtremeXOS and Switch Engine 31.7 Feature License Requirements document.