configure vrrp vlan vrid add track-iproute

configure vrrp vlan vlan_name vrid vridval add track-iproute ipaddress/masklength

Description

Creates a tracking entry for the specified route. When this route becomes unreachable, this entry is considered to be failing.

Syntax Description


`vlan_name`	Specifies the name of a VRRP This command is available on the ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X590, X620, X670-G2, X690, X695, X870, 5320, 5420, 5520 series switches..
`vridval`	Specifies the VRID of the target VRRP instance. To display the configured VRRP router instances, enter the show vrrp command.
`ipaddress`	Specifies the IPv4 or IPv6 prefix of the route to track.
`masklength`	Specifies the length of the route's prefix.

Default

N/A.

Usage Guidelines

The route specified in this command might not exist in the IP routing table. When you create the entry for a route, an immediate VRRP failover might occur.

Note

VRRP tracking is not supported on MPLS LSPs.

Example

The following command enables IP route failure tracking for routes to the specified subnet:

configure vrrp vlan vlan-1 vrid 1 add track-iproute 3.1.0.0/24

History

This command was first available in ExtremeXOS 10.1.

Platform Availability

This command is available on platforms that support the appropriate license. For complete information about software licensing, including how to obtain and upgrade your license and which licenses support the VRRP feature, see the ExtremeXOS and Switch Engine 31.7 Feature License Requirements document.