This command configures DHCPv4 server/next hop relay for each This command is available on the ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X590, X620, X670-G2, X690, X695, X870, 5320, 5420, 5520 series switches. IPv4 interfaces. This command is not applicable to IPv6 interfaces. Configuring bootprelay per VLAN v4 level is supported only on IPv4, and not on IPv6.
| bootprelay | BOOTP Relay service. |
| add | Adds DHCP BOOTP Relay server. |
| delete | Deletes DHCP BOOTP Relay server. |
| ip_address | IP address of bootp relay server. |
N/A.
Use this command to configure the DHCPv4 server/next hop for each VLAN interface. The configuration applied to the VR level is populated to all VLAN v4 IPv4/v6 interfaces.
The following example displays IPv6 bootprelay information:
# sh bootprelay configuration ipv4
DHCPv4 BOOTP Relay : Enabled on virtual router "VR-Default"
Include Secondary : Disabled
BOOTP Relay Servers : 10.127.6.243
DHCP Relay Agent Information Option: Disabled
DHCP Relay Agent Information Check : Disabled
DHCP Relay Agent Information Policy: Replace
VLAN DHCPv4 BOOTP Relay
------------------------ ------------------
VLAN "Default":
BOOTP Relay : Enabled
VLAN "client":
BOOTP Relay : Enabled
BOOTP Relay Servers : 10.1.1.1 10.127.6.101 10.127.6.243
DHCP Relay Agent Information Option: Disabled
DHCP Relay Agent Information Check : Disabled
DHCP Relay Agent Information Policy: Replace
VLAN "client1":
BOOTP Relay : Enabled
VLAN "dhcpv4server":
BOOTP Relay : Enabled
VLAN "server":
BOOTP Relay : Enabled
This command was first available in ExtremeXOS 15.5.
This command is available on ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, X670-G2, X690, X695, X870, 5320, 5420, and 5520 series switches.