Displays information about synchronous Ethernet (SyncE).
|
port_list |
Specifies the port(s). |
|
details |
Show additional details. |
N/A.
Use this command to display the SyncE configuration and port state on one or more ports. The following command will display the SyncE configuration and port state for all ports:
show network-clock sync-e ports
The following command displays SyncE information for ports 1 - 12:
show network-clock sync-e ports 1-12
Following is sample output:
===================================================================
Port Flags Input Configured Output Source
Clock Quality Clock Quality Clock Quality (Port Number)
===================================================================
1 S2 QL-SSU-A
2 S1 QL-PRC
3 S
4 S
5 S
6 S QL-PRC SOURCE-1 (2)
7 S
8 S
9 S
10 S
11 S
12 S
===================================================================
Flags : (S) SyncE Supported, (N) SyncE Not Supported,
(O) SyncE Supported for Output Only,
(E) SyncE Enabled, (f) Forced Source Clock,
(1) Clock Source 1, (2) Clock Source 2,
This command was first available in ExtremeXOS 15.1.
This command is available on the ExtremeSwitching X460-G2.