process-monitor

Profile Config Commands

Configures a watchdog process to monitor the Radio Interface Module (RIM). If the RIM process is not running or is killed, the watchdog re-initializes the RIM.

Note

This command and its syntax is common to both Profile and Device commands. You can apply overrides to RIM monitoring at the device level. Overrides applied at the device level take precedence.

Supported on the following devices:

Access Points: AP3000, AP3000X, AP5010, AP310i/e, AP410i/e, AP505i, AP510i/e, AP560i, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

process-monitor

Parameters

process-monitor


process-monitor	Enables monitoring of the RIM processes and, if necessary, re-initializes the RIM

Example

vx9000-1A1809 (config-profile-anyap-test)# process-monitor

Related Commands


no	Disables monitoring of the RIM processes (applies to both profile and device configurations)
remove-override	Completely removes the override configuration from the individual device (does not apply to profile configuration)