pppoe-client

Displays PPPoE client information. Use this command to view PPPoE statistics derived from access to high-speed data and broadband networks. PPPoE uses standard encryption, authentication, and compression methods as specified by the PPPoE protocol. PPPoE enables point-to-points connection to an ISP over existing Ethernet interface.

Supported on the following devices:

Access Points: AP3000/X, AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

show pppoe-client [configuration|status] {on <DEVICE-NAME>}

Parameters

show pppoe-client [configuration|status] {on <DEVICE-NAME>}


pppoe-client	Displays PPPoE client information (configuration and status)
configuration	Displays detailed PPPoE client configuration
status	Displays detailed PPPoE client status
on <DEVICE-NAME>	The following keywords are common to ‘configuration' and ‘status' parameters: on <DEVICE-NAME> – Optional. Displays detailed PPPoE client status or configuration on a specified device <DEVICE-NAME> – Specify the name of the AP, wireless controller, or service platform.

Examples

nx9500-6C8809#show pppoe-client configuration
 PPPoE Client Configuration:
+-------------------------------------------
|  Mode          : Disabled
|  Service Name  :
|  Auth Type     : pap
|  Username      :
|  Password      : fJx5O+5duPjaOaPuXmtLDQAAAAAmvgEXcQ1+eUK4ByHK4aRi
|  Idle Time     : 600
|  Keepalive     : Disabled
|  Local n/w     : vlan1
|  Static IP     : __wing_internal_not_set__
|  MTU           : 1492
+-------------------------------------------

nx9500-6C8809#