http

Configures the HTTP server settings used to authenticate HTTP connection to a EX3500 switch

Management access to an EX3500 switch can be enabled/disabled as required using separate interfaces and protocols (HTTP, SSH). Disabling unused and insecure interfaces and unused management services can dramatically reduce an attack footprint and free resources within an EX3500 management policy.

Supported in the following platforms:

Service Platforms — NX 95XX, NX 96XX, NX 7510

Syntax

http [port <1-65535>|secure-port <1-65535>|secure-server|server]

Parameters

http [port <1-65535>|secure-port <1-65535>|secure-server|server]


http	Configures following HTTP settings: port, secure-port, secure-server, and server
port <1-65535>	Configures the HTTP port number. This is the port used to connect to the HTTP server. <1-65535> – Specify a value from 1 - 65535. The default port is 80.
secure-port <1-65535>	Enables secure HTTP connection over a designated secure port. Ensure that the HTTP secure server is enabled before specifying the secure-server port. <1-65535> – Specify the secure HTTP server port from 1 - 65535. The default port is 443.
secure-server	Enables HTTP secure server. This option is disabled by default.
server	Enables HTTP server. This option is enabled by default. Consequently, HTTP management access is allowed by default.

Examples

nx9500-6C8809(config-ex3500-management-policy-test)#http secure-server

nx9500-6C8809(config-ex3500-management-policy-test)#show context
ex3500-management-policy test
 http secure-server
 enable password level 3 7 12345678901020304050607080929291
 snmp-server notify-filter 1 remote 127.0.0.1
nx9500-6C8809(config-ex3500-management-policy-test)#

Related Commands


no (ex3500-management-policy-config-mode)	Reverts to default HTTP server settings (HTTP server enabled, HTTP port 80)