Creates an RTL server policy and enters its configuration mode. When configured and applied on an access point, this policy enables the sending of RSSI feeds from the access point to a server. The RTL server policy provides the exact location (URL) of the server. The RSSI feeds sent are as per the sensor-policy configured and applied on the access point. Therefore, ensure that a sensor-policy, with the rssi-interval-duration specified, is existing, configured, and applied on the access points.
To initiate RSSI feed posts to the Euclid locationing server, use the RTL server policy on the:
Service Platforms —
NX5500, NX7500, NX9500, NX9600
Virtual Platforms —
CX9000, VX9000
Syntax
rtl-server-policy <RTL-POLICY-NAME>
Parameters
rtl-server-policy <RTL-POLICY-NAME>
<RTL-POLICY-NAME>
Specify the RTL server policy name. If an RTL server policy with the specified name does not exist, it is created.
nx9500-6C8809(config)#rtl-server-policy test
nx9500-6C8809(config-rtl-server-policy-test)#?
RTL Server Policy Mode commands:
no Negate a command or set its defaults
url Configure the url to send the real time RSSI feed to
clrscr Clears the display screen
commit Commit all changes made in this session
do Run commands from Exec mode
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
help Description of the interactive help system
revert Revert changes
service Service Commands
show Show running system information
write Write running configuration to memory or terminal
nx9500-6C8809(config-rtl-server-policy-test)#
Documents the ‘use‘ command in a device‘s profile or device configuration context. Use this option to associate this RTL server policy to an access point‘s profile or device.
Documents the ‘use‘ command in the RF Domain configuration context. Use this option to associate this RTL server policy to an RF Domain. When associated, the policy is applied to all access points within the RF Domain.
