ra

Configures RA related parameters, such as the interval between two unsolicited successive RAs. It also allows suppression of RAs.

Supported on the following devices:

Access Points: AP3000/X, AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

ra [interval <3-1800>|suppress]

Parameters

ra [interval <3-1800>|suppress]


interval <3-1800>	Configures the interval, in seconds, between two unsolicited successive RAs <3-1800> – Specify a value from 3 - 1800 seconds. The default is 300 seconds. Note: The router-lifetime should be at least three times the specified router interval.
suppress	Enables the suppression of RAs. When enabled, the transmission of RAs in IPv6 packets is suppressed. This option is disabled by default. The no > ra > suppress command enables the sending of RAs.

Examples

nx9500-6C8809(config-ipv6-radv-policy-test)#ra interval 200

nx9500-6C8809(config-ipv6-radv-policy-test)#ra suppress

nx9500-6C8809(config-ipv6-radv-policy-test)#show context
ipv6-router-advertisement-policy test
 ra suppress
 ra interval 200
 managed-config-flag
 nd-reachable-time global
 advertise mtu
 advertise hop-limit
 check-ra-consistency
 dns-server 2002::2 lifetime 3000
 domain-name TechPubs lifetime infinite
nx9500-6C8809(config-ipv6-radv-policy-test)#

Related Commands


no (ipv6-ra-policy-config-commands)	Removes the RA interval, and enables the sending of RAs