Print this pagePrint this page

Email this topicEmail this topic

View PDFView PDF

Download EPUBDownload EPUB

use-filter-ip1 to use-filter-ip4

Use the use-filter-ip1 to use-filter-ip4 commands to apply the IP Address filters you have created.
Note

Note

Excessive packet capture degrades network performance. When enabling packet capture on all APs, specify at least one MAC address filter to avoid performance degradation.
use-filter-ip1 enable | disable, use-filter-ip2 enable | disable, use-filter-ip3 enable | disable, use-filter-ip4 enable | disable

Parameters

use-filter-ip1 enable | disable to use-filter-ip4 enable | disable Use the use-filter-ip1 to use-filter-ip4parameters to enable or disable the IP Address filters.
  • enable — Enables the IP Address filter.
  • disable — Disables the IP Address filter.

Example

The following example applies the filter-ip1 filter on a wireless AP3912i:

EWC.extremenetworks.com:ap-traffic-capture# use-filter-ip1 enable

Related Topics

filter-ip1 to filter-ip4
Published May 2018prev | next

Email this topicEmail this topic

Print this pagePrint this page