Use the radio-share-mode command to configure the radio mode for the Radio Share profile.
The radio-share-mode command is accessible from within the mitigator: shareprof: <named share profile> context of the CLI.
off | When the radio mode is set to Off, the Radio Share capability is disabled. |
inline | AP reports to the ADSP server only multicast / broadcast traffic such as beacons and probe requests. Inline mode has minimal impact on AP performance, because the AP reports to the ADSP server only traffic that it processes. Default setting. |
promiscuous | AP receives all
packets seen on its operating channel and forwards them to the ADSP server.
Promiscuous mode loads the AP resources, because the AP processes traffic intended
for all neighboring APs. In high-density, wireless deployments, use dedicated
sensors instead of Radio Share in Promiscuous mode. Note: Set AP to Promiscuous mode
when AP is required to perform Termination.
|
The following example sets the radio share mode to promiscuous:
EWC.extremenetworks.com:mitigator:shareprof:radioshare# radio-share-mode promiscuous