Print this pagePrint this page

Email this topicEmail this topic

View PDFView PDF

Download EPUBDownload EPUB

use-filter-mac1 to use-filter-mac2

Use the use-filter-mac1 and use-filter-nmac2 commands to apply the MAC Address filters you have created.
Note

Note

Excessive packet capture degrades network performance. When enabling packet capture on all APs, specify at least one MAC address filter to avoid performance degradation.
use-filter-mac1 enable | disable, use-filter-mac2 enable | disable

Parameters

use-filter-mac1 enable | disable and use-filter-mac2 enable | disable Use the use-filter-mac1 and use-filter-mac2 parameters to enable or disable the MAC Address filters.
  • enable — Enables the MAC Address filter.
  • disable — Disables the MAC Address filter.

Example

The following example applies the filter-mac1 filter on the wireless AP AP3912i:

EWC.extremenetworks.com:ap-traffic-capture# use-filter-mac1 enable
Published May 2018prev | next

Email this topicEmail this topic

Print this pagePrint this page