Configure LLDP-MED Coordinate Based Location Information

About this task

Perform the following procedure to configure coordinate based location information of local LLDP-MED on specific ports.

Procedure

Enter GigabitEthernet Interface Configuration mode:

enable

configure terminal

interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}

Note

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
Configure coordinate based location:

lldp location-identification coordinate (altitude WORD<1-13> {floors | meters} datum {NAD83/MLLW | NAD83/NAVD88 | WGS84} latitude WORD<1-14> {NORTH | SOUTH} longitude WORD<1-14> {EAST | WEST})

Example

Configuring coordinate based location on port 1/2:

Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#interface gigabitEthernet 1/2
Switch:1(config-if)#lldp location-identification coordinate-base altitude 3 floors

Variable Definitions

The following table defines parameters for the lldp location-identification coordinate command.


Variable	Value
altitude `WORD<1–13>`	Specifies the value for altitude. The units of measurement are: `floors` `meters`
datum	Specifies the reference datum. The formats are: NAD83/MLLW NAD83/NAVD88 WGS84
latitude `WORD<1-14>`	Specifies the latitude in degrees, and its relation to the equator from North or South.
longitude `WORD<1-14>`	Specifies the longitude in degrees, and its relation to the prime meridian from East or West.