Enabling DiffServ on a port

Enable DiffServ so that the system provides DiffServ-based QoS on the port. By default, DiffServ is enabled.

Procedure

Enter Interface Configuration mode:

enable

configure terminal

interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]} or interface vlan <1–4059>

Note

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
Enable DiffServ:

enable-diffserv [port {slot/port[/sub-port][-slot/port[/sub-port]][,...]}] [enable]
Disable Diffserv:

no enable-diffserv [port {slot/port[/sub-port][-slot/port[/sub-port]][,...]}] [enable]

Use the data in the following table to use the enable-diffserv command.


Variable	Value
enable	Enables DiffServ for the specified port. The default is enabled.
port `{slot/port[/sub-port] [-slot/port[/sub-port]] [,...]}`	Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.