System Profile Configuration - General Screen

An access point profile requires unique clock synchronization settings as part of its general configuration.

The NTP (Network Time Protocol) is a client-server implementation that manages time and/or network clock synchronization within the network. Controllers, service platforms, and access points (NTP clients) periodically synchronize their clock with a master clock (an NTP server). For example, an access point resets its clock to 07:04:59 upon reading a time of 07:04:59 from its designated NTP server.

To define a profile‘s general configuration:

  1. Select Configuration → Devices → System Profile from the Web UI.
    A list of device profiles is displayed in the right-hand UI. This list contains default and user-defined profiles.
  2. Select a device profile from the list.
    General configuration options display by default, with the profile activated for use with this access point model.
    Click to expand in new window
    General Profile Screen
    GUID-B8493DAB-4F11-4E09-AEC2-75E66F7515F9-low.png
  3. Select the Set as Virtual Controller AP checkbox, to configure this AP as VC.
    Note

    Note

    WiNG 7.1 does not support VC configuration on AP505 and AP510 model access points.
  4. If you set the AP is a VC, select the Adopt Unknown APs Automatically checkbox.
    Note

    Note

    WiNG 7.1 does not support VC configuration on AP505 and AP510 model access points.
  5. Select + Add Row below the Network Time Protocol (NTP) table to define the configurations of NTP server resources used to obtain system time. Up to three NTP servers can be configured. Set the following parameters to define the NTP configuration:
    Server IP Set the IP address of each server added as a potential NTP resource.
    Key Number Select the number of the associated authentication peer key for the NTP resource.
    Key Enter a 64 character maximum key used when the autokey setting is set to false (disabled). Select the Show option to expose the actual character string comprising the key.
    Preferred Select this option to designate this NTP resource as a preferred NTP resource. This setting is disabled by default.
    AutoKey Select the check box to enable an autokey configuration for the NTP resource. The default setting is disabled.
    Version Use the spinner control to specify the version number used by this NTP server resource. The default setting is 0.
    Minimum Polling Interval Use the drop-down menu to select the minimum polling interval. Once set, the NTP resource is polled no sooner then the defined interval. Options include 64, 128, 256, 512 or 1024 seconds. The default setting is 64 seconds.
    Maximum Polling Interval Use the drop-down menu to select the maximum polling interval. Once set, the NTP resource is polled no later then the defined interval. Options include 64, 128, 256, 512 or 1024 seconds. The default setting is 1024 seconds.
  6. Use the RF Domain Manager field to configure how this access point behaves in standalone mode. Set the following parameters:
    Capable Select to enable this access point to act as a RF Domain Manager in a particular RF Domain.
    Priority Select to prioritize this access point in becoming a RF Domain Manager in its; particular RF Domain. The higher the value, the more likely the device becomes the RF Domain Manager for the domain.
  7. Select OK to save the changes made to the general profile configuration.

    Select Resetto revert to the last saved configuration.