Reenabling an operationally disabled port

Reenable a port that has been operationally disabled by SLPP Guard.

Note

You cannot reenable a disabled port if the timer count has not reached its timeout value. Either wait until it reaches the timeout or disable SLPP Guard for that port and then re-enable it.

1. Enter GigabitEthernet Interface Configuration mode:

   enable

   configure terminal

   interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}

   

   Note

   If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

2. Reenable SLPP Guard on the port:

   slpp-guard enable

3. Optional: Configure the timeout value on the port:

   slpp-guard timeout {<10-65535> | 0}

Example

Switch:1(config-if)#slpp-guard enable
Switch:1(config-if)#slpp-guard timeout 120