Configuring additional addresses on the VRRP interface

Perform this procedure to configure the additional addresses for which the virtual router acts as a back up.

Before you begin

  • Assign an IPv6 address to the interface.

  • Enable routing globally.

  • Do not configure RSMLT on the VLAN.

  • Change the VRF instance as required to configure additional addresses on the VRRP interface on a specific VRF instance. Not all parameters are configurable on non-default VRFs.

Procedure

  1. In the navigation tree, expand the following folders: Configuration > IPv6.
  2. Click VRRP.
  3. Click the Interface tab.
  4. Select an interface.
  5. Click AssociatedIPAddr.
  6. Click Insert.
  7. Type the address.
  8. Type the prefix length.
  9. Click Insert.

Address List field descriptions

Use the data in the following table to use the Address List tab.

Name

Description

IpAddr

Specifies an IP address that is associated with a virtual router. The number of rows on this tab equals the number of IP addresses associated (backed up) by the virtual router

IpAddrPrefixLength

Specifies the length of the prefix in bits.

9037588-00 Rev AA