Configuring RIPng route distribution

Configure a redistribute entry to announce certain routes into the RIPng domain, including static routes, direct routes, Open Shortest Path First (OSPFv3), IS-IS, or Border Gateway Protocol (BGP+).

Before you begin

Enable RIPng globally.

Procedure

Enter Global Configuration mode:

enable

configure terminal
Access router RIP configuration mode:

router rip
Enable the redistribution:

ipv6 redistribute {direct|isis|static|ospf|bgp} enable
Ensure the configuration is correct:

show ipv6 rip redistribute

Example

Enable the redistribution instance.

Switch:1#enable
Switch:1#configure terminal
Switch:1(config)#router rip
Switch:1(config-rip)#ipv6 redistribute bgp enable
Switch:1(config-rip)#ipv6 redistribute direct enable
Switch:1(config-rip)#ipv6 redistribute isis enable
Switch:1(config-rip)#ipv6 redistribute ospf enable
Switch:1(config-rip)#ipv6 redistribute static enable
Switch:1(config-rip)#show ipv6 rip redistribute

================================================================================
                            RIPng Redistribute List
================================================================================
        direct                         : enabled
        static                         : enabled
        ospf                           : enabled
        bgp                            : enabled
        isis                           : enabled
--------------------------------------------------------------------------------

Variable definitions

Use the data in the following table to use the ipv6 redistribute command.


Variable	Value
<bgp\|direct\|isis\|ospf\|static>	Specifies the type of routes to redistribute (the protocol source). Valid options are bgp, isis, direct, ospf, or static.